NXG Technology NX-PRO6220 - Manual (Page 2)

FIG. 4
(Continued from front)
NXG Speakers Three-Year Limited Warranty
If the NXG speaker system proves to be defective in workmanship or materials
within three years from the date of the original customer’s purchase, we will, at our
option, repair or replace the defective product.
Limitation of Implied Warranties
Any implied warranties, including warranties of merchantability and fitness for a
particular purpose, are limited in duration to the length of this warranty.
Exclusion of Certain Damages
NXG’s liability for any defective product is limited to repair or replacement of the
product at our option. NXG shall not be liable for incidental or consequential
damages of any kind or character because of product defects. Some states do
not allow limitations on how long an implied warranty lasts and/or do not allow
the exclusion or limitation of incidental or consequential damages, so the above
limitations and exclusions may not apply.
This Warranty Does Not Cover:
• Damage caused by abuse, accident, misuse, negligence, or improper operation.
• Any product whose serial number has been altered, defaced, or removed.
• Products that have been altered or modified.
• Normal wear and maintenance.
• Damages caused by shipping. (All claims for shipping damage must be made
with the carrier.)
speaker’s interior black surface, woofer and tweeter. Paint the
outer speaker frame and grille separately. (Grille painting hint:
Use a paint roller that is nearly out of paint to first paint the
inside of the grille, then the outside. This will avoid paint filling
the grille perforations.)
5. Attach the wire to the input terminals on the rear of the
speaker. Remember to maintain proper polarity with the
amplifier by attaching the positive (+) lead to the red terminal
and the negative (-) lead to the black terminal.
6. See Fig. 5. With the speaker wire attached to the speaker,
slide the speaker up inside the cut-out hole. Center the
speaker in the cut-out hole and turn the six locking screws
clockwise until the speaker is drawn up snugly to the wall
board from behind, clamping the speaker in place. Try to
tighten each screw equally. Replace the speaker grill by gen-
tly pressing it into place.
New Construction
1. Determine speaker locations and mark them on your plans
for future reference.
2. If possible, run speaker wires after HVAC and electrical
wiring is in place.
3. Secure speaker wires in place along the run with insulated
staples only and be careful not to pierce the wire’s insulation.
Allow a bit of slack for expansion of building materials.
4. Needless to say, the actual speakers should not be installed
until the wall board is in place. In the meantime, leave several
feet of wire coiled up and secured at the back side of the
mounting hole.
5. To complete the installation follow steps 2 through 5 above.
Operational Check
After making all connections it’s a good idea to make sure
everything is working properly. Turn on your surround or
stereo system making sure the volume control is turned down
and that the balance control is in the center position. Activate a
musical or movie source such as FM, a CD or DVD player.
Gently turn up the volume, you should hear sound coming
from your new NXG speakers. If no sound is heard from any or
all speakers, switch off the system immediately and check for
open or loose connections, wrong polarity or shorts, or proper
source selection.
FIG. 5
NX-PRO6220 Specifications
Power Handling: 5 - 120 watts
Efficiency: 90dB @ 1 watt/1 meter
Frequency Response: 40 Hz - 22,000 Hz
Driver Complement: 6 1 /
2
˝ (165 mm) metallic anodized injection molded
radiative cone woofer w/rubber surround
1˝ (25 mm) pivoting liquid-cooled metallic anodized
dome tweeter
Impedance: 8 ohms nominal, 6 ohms minimum
Grille: Corrosion-resistant powder coated aluminum
Overall Dimensions: 12 1 /
8
˝ H x 8 5 /
8
˝ W x 3 1 /
2
˝ D
Required Wall Cut-out: 10 7 /
8
˝ x 7 1 /
2
˝
Warranty Service
Warranty service must be performed by an authorized service center, usually an
NXG speaker systems dealer or its authorized agent. You may obtain a list of
authorized service centers by contacting NXG.
All warranty repairs must be accompanied by
the original bill of sales. No other document is
acceptable or is required. This warranty gives
you specific legal rights, and you may also have
other rights which vary from state to state.
NXG reserves the right to revise speaker system
specifications without notice.
16648 North 94th Street
Scottsdale, AZ 85260
1-800-733-0008