Kendall Howard 5500-3-100-02 Training Table Keyboard Tray - Manual (Page 2)

Tools Needed:
2
Screw Driver
(4x) 1/4-20 Screws
a. Line up keyboard tray brackets/slides with the pre-drilled
holes in the table top surface
b. Make sure the notch in the slide rails is facing the rear of the
table
Included:
Notch to the REAR
Assembly - Step 1:
(2) Bracket/Slides
Assembly - Step 2:
3
a. Secure with included 1/4” screws
Assembly - Step 3:
a. Insert Keyboard Tray into mounted slides.
To utilize as a Keyboard Tray insert with hollow area facing down
To utilize as a Pencil Drawer insert with hollow area facing up