Braun OC15525 OxyJet 3D Center - Manual (Page 12)

12
Pressure sensor
For safety and optimum brushing results, the plaque
remover has a pressure control system: If too much
pressure is applied, the oscillating movement of the
brushhead will continue, but the pulsation will stop.
There is a noticeable change in feeling and sound when
the pressure sensor is activated.
Memory timer
An incorporated timer memorises the elapsed brushing
time, even when the handle is briefly switched off (max.
30 seconds). After two minutes – which is the minimum
recommended brushing time – the timer signals by a short
stutter.
INDICATOR ® brushhead
Dentists recommend that you replace any toothbrush
every 3 months, since worn bristles do not remove plaque
as effectively as new ones. Therefore, the brushhead is
provided with indicator bristles. With proper brushing
twice a day for two minutes using toothpaste, the colour
will disappear half-way down the bristles in a 3-month
period.
After use
Rinse the brushhead thoroughly under running water for
several seconds with the handle switched on. Switch off
the handle and take off the brushhead. Clean both parts
separately under running water, then wipe them dry.
Environmental notice
The plaque remover handle is provided with a nickel-
hydride rechargeable battery. To protect the environment,
do not dispose of the product in the household waste at
the end of its useful life. Open the handle as shown,
remove the battery and dispose of it at your retail store or
at appropriate collection sites according to national or
local regulations.
Caution : Opening the handle will definitely destroy it.
5
7
2
3
6
4
1
4715119_ OC15X_P4-96 Seite 12 Mittwoch, 11. Oktober 2000 7:31 07