Ultimate Support LTV-24B - Manual (Page 2)

3
z Convert a speaker stand into a lighting tree.
z 48” crossbar has 4 pre-drilled holes for mounting hardware (included), AND is
thick-walled for use with C-clamps (not included).
z Weight Rating: 60 lbs. (27.2 kg)
z Parts:
1) 48” tube with end plugs
1) 2-piece hatched t-fitting
2) Universal fittings 1) Hardware packet
LTB-48B Crossbar Setup
LTV-24B Vertical Extension
STEP 2: Assemble each T-fitting with the 3 Handknobs. Install
hex nuts, insert Handknob with washer - loosely tighten
Handknobs.
STEP 4: Optional: Slide one Universal Fitting for dimmer packs
on the Tube - place on either side of the T-fitting. Install
Handknobs.
STEP 5: Slide T-Fitting over top tube of the tripod stand and
tighten corresponding Handknobs onto top tube. Tighten
Handknob for the Crossbar Tube.
STEP 6: Assemble mounting Hardware through par can yoke or
other lighting effect in order shown (bolt, washer, saddle, tube,
saddle, washer, t-nut). OR tighten C-clamps directly onto the
tube.
STEP 1: Set up tripod stand following enclosed instructions.
STEP 7: Raise height of lighting tree following enclosed
tripod instructions.
2.
3.
5
.
6.
STEP 3: Slide T-fitting to middle of the Crossbar Tube. Leave
Handknob loose.
z Add a second tier to your lighting tree.
z Each 24” crossbar arm has 2 pre-drilled holes for mounting hardware (included),
AND is thick-walled for use with C-clamps (not included).
z Weight Rating: 20 lbs. (9.1 kg) per arm
z Parts:
2) 24” tubes with end plugs 2) 2-piece hatched t-fitting
2) Universal fittings
1) Hardware packet
STEP 1: Set up tripod stand following enclosed instructions.
STEP 2: Follow LTB-48B Step 2 for assembling T-fittings.
STEP 3: Optional: Follow LTB-48B Step 4 for Universal
Fitting - one per tube.
STEP 4: Slide closed end of T-fitting back on the open end
of the Tube. Tighten corresponding Handknobs.
STEP 5: Slide T-fittings (with Tubes in a horizontal line) over the top tube of the
tripod stand (inset). Tighten remaining Handknobs.
STEP 6: Follow LTB-48B Step 6 for attaching par cans or other lighting effects to
the Crossbar Tube.
STEP 7: Raise height of lighting tree following enclosed tripod instructions.
2
LTB-24B Crossbar Pair Setup
z Make a lighting tree 24” taller.
z Parts:
1) 24” tubes with end plug
and connector
1) Hardware packet
STEP 1: Place Extension Tube
over top of the speaker
stand.
STEP 2: Tighten socket-head cap
screws with allen wrench.
Special Instructions
1. Follow all Setup and Special
Instructions on enclosed Tripod
Stand sheet.
2. Universal Fittings are intended for
use with dimmer packs only - DO
NOT USE WITH LIGHTING
FIXTURES.
3. Distribute weight equally over
Lighting Tree System.
4. Check that handknobs are secure
when supporting equipment and
always loosen handknobs with
caution.