Imetec INTELLIVAPOR ECO - Manual (Page 14)

EN
12
IMPORTANT GUIDELINES
The appliance is designed to work with tap water; however, if the water in your area is
very hard, mix the tap water (50%) with distilled and/or demineralised water (50%). Salt
concentration in water in certain seaside areas is very high: in such cases it is important to
use "demineralised water for irons" available on the market. If in doubt, only demineralised
water for steam irons must be used.
Do not use diluting agents, scented liquids or descaling agents as these substances can
damage the product.
Do not use water from dryers, air-conditioners and rain water.
The boiler may contain some water as each product is tested before being put on the market.
It is recommended to place a cloth between the iron and the fabric when using the iron for
the first time.
It is recommended to direct a jet of steam into the air before starting to iron, for any residual
condensation to be let out.
SYMBOLS
WARNING
PROHIBITION
DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES
Refer to the illustrative guide at the beginning of this booklet to verify your appliance
equipment. All the figures are on the cover pages of these instructions for use.
1. Removable water reservoir
2. Cleaning cap
3. ON/OFF button
4. Plug
5. ECO button
6. Steam (ready) LED (green)
7. Boiler cleaning LED (yellow)
8. No water LED (blue)
9. Iron mat
10. Cable duct
11. Plate temperature LED
12. Multi-hole plate
13. Steam button