P38 connections, Connecting to loudspeakers, Other connections – Arcam FMJ A38 User Manual
Page 14
e-14
P38
connections
�����������������
�����������
��
�
�
�������
������
������
��
����
���
�����������������
���
����������
���
���
������������������
����
�����������������
�����������������
�����
connecting to loudspeakers
The P38 amplifier may be connected by simple wiring,
bi-wiring or bi-amping – see page 9 for details. In
addition, see the following section on the Mono Link
(and the diagram below) for another way of bi-amping
loudspeakers using a pair of P38s.
other connections
The P38 amplifier provides the following connections:
audio in
Connect the output sockets of your pre-amp. (or the
PrE out
sockets of an integrated amplifier, such as the
A38) to one of these inputs.
Mono link
The P38 can be adapted to provide two mono
loudspeaker outputs from a single input. Using a pair of
P38s (i.e. one power amplifier per loudspeaker) enables
you to bi-amplify a pair of compatible loudspeakers,
reducing the amount of cross-talk between channels
compared with using the P38 in a more conventional
stereo configuration.
1. Connect the
rIGht
channel from your pre-amp
(or
PrE out r
from an A38) to the socket labelled
AudIo In r
on your first P38.
2. Pull out the link supplied on the back panel
(labelled ‘link’), and use it to connect the left and
right
AudIo out
sockets together.
3. Repeat steps 1 and 2 on your second P38, but
this time connect the
LEft
channel from your
pre-amp (or
PrE out L
from an A38) to the socket
labelled
AudIo In L
.
4. Follow the diagram (left) for bi-wiring each
speaker, using the
sP2
connections of the P38
for the high-frequency speaker and the
sP1
connections for the low-frequencies in each case.
daisy chaining more amplifiers
The P38 can be connected to further power amplifiers
to drive more speakers (e.g., those in other rooms,
tri-amplified speakers, etc). This technique is called
‘Daisy chaining’.
Connect the
AudIo out
sockets on the P38 to the
pre-amp input of the next amplifier in series, left to left,
right to right.
Note that daisy-chaining cannot be used if the Mono
Link (previously described) is in use.
���������
�
�
�
�
���������
�
�
�
�
���������
�
�
������
���������
���������
Using a pair of P38s with the Mono Link to bi‑amplify a pair of speakers