AEG TG340 - Manual (Page 17)

17
g
5
g
Dear customer,
Please read these operating instruc-
tions through carefully and keep it for
future reference.
1 Warning
0 Operating guide
3 Information
2 Information on economical and envi-
ronmentally friendly use.
Description of the
appliance
1 Base frame
2 Drip tray
3 Thermostat with mains cable
a Operating lamp
4 Heater plate (non-stick) with cool
touch handles and:
b Frying surface
c Grill bars
1 Safety instructions
• The appliance may only be connected
to a power supply whose voltage and
frequency comply with the specifica-
tions on the rating plate!
• Never use or pick up the appliance if
– the supply cord is damaged,
– the housing is damaged.
• If the appliance or the supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or simi-
larly qualified person, in order to avoid
hazard.
• This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
given supervision or instruction con-
cerning use of the appliance by a per-
son responsible for their safety.
• Never leave the appliance unattended.
• Children should be supervised to
ensure that they do not play with the
appliance.
• Caution, the temperature of accessible
surfaces may be high when the appli-
ance is operating. Always lift only with
the thermally insulated handles.
• The mains cable must not come into
contact with any hot parts of the
appliance. Never place the appliance
over or near a naked flame, hot plate
or hot oven.
• The mains cable with thermostat must
never become wet. Never clean under
running water or even in rinsing water.
• The appliance must only be connected
to an earthed socket. If necessary an
extension cable suitable for 10 A can
be used.
• Place the appliance only on an abso-
lutely flat, stable surface and not on
sensitive surfaces.
• Observe the necessary safe distances
from walls and curtains and do not
bring any easily inflammable material
(e.g. plastic film, etc.) near the appli-
ance.
• The grill plate must only be put into
operation on the base frame and with
the drip tray fitted.
• Appliance is for indoor use only.
• Please make sure before use that the
plug contacts on the heater plate are
dry.
• The appliance must be switched off
and the mains plug withdrawn each
time before cleaning and maintenance.
• The manufacturer cannot accept any
liability for possible damage caused by
improper or incorrect use.
Operation
Before using for the first time remove
any stickers on the appliance and clean
it thoroughly (see "Cleaning and care").
Do not use any metal utensils on the
grilling surface to prevent damage to
the non-stick coating!
English
822_949_466 TG340_AEG.book Seite 5 Freitag, 8. Mai 2009 7:22 19
g
6
0
Preparing the table grill
Insert drip tray ( 2) in base frame (1).
Inserting the heater plate ( 4) in the
base frame ( 1).
Apply a little cooking oil to the surface
of the heater plate each time before
use with the aid of kitchen paper for
better non-stick properties.
Insert the thermostat with mains cable
( 3) fully in the socket on the appliance.
The thermostat can only be fitted
when the heater plate ( 4) is in the cor-
rect location in the base ( 1).
0
Working with the table
grill
Connect the mains cable ( 3) to the
socket.
Turn the thermostat (
3) to the desired
setting (1 to 5).
1 = lowest temperature
5 = highest temperature
3 The operating lamp ( 3/a) on the ther-
mostat is on while the grill is heating
up. When the temperature is reached,
heating takes place at intervals to
maintain the temperature constant.
To switch off the appliance, turn the
thermostat to "OFF".
Practical tips
• The grill bars (4/c) are ideal for the
preparation of meat, fish and poultry.
Fat and juice can fall into the drip tray
through the grill webs. This ensures a
healthy, low-fat preparation.
• The frying surface (4/b) is ideal for
example for the preparation of eggs,
ham, mushrooms, tomatoes, onions,
etc. It is also very well suited for keep-
ing food warm.
0
Cleaning and care
Remove the mains plug from the
socket.
Allow the appliance to cool down.
Disassemble the appliance. The heater
plate can only be removed from the
base frame after the thermostat has
been removed.
The heater plate can be cleaned in the
dishwasher or manually.
Thermostat, drip tray and base frame
should be cleaned with a damp cloth
(not safe for dishwasher).
Dry all parts thoroughly before reas-
sembling the appliance.
1 Note that water must not penetrate
inside the thermostat under any cir-
cumstances!
Never clean under running water or
even in rinsing water.
Storage
It is best to store the table grill assem-
bled.
Technical data
Mains voltage: 230 V
Power consumption: 2200 W
Disposal
2 Packaging material
The packaging materials are environ-
mentally friendly and can be recycled.
The plastic components are identified
by markings, e.g. >PE<, >PS<, etc.
Please dispose of the packaging mate-
rials in the appropriate container at
the community waste disposal facili-
ties.
822_949_466 TG340_AEG.book Seite 6 Freitag, 8. Mai 2009 7:22 19
ELX12837_Tina_tablegrill_AEG.indd 17 2009-08-25 16:10:29