Zanussi ZRG716SW - Manual (Page 21)

Problem Possible cause Solution
The temperature in the ap-
pliance is too high. The temperature regulator is not set
correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high. Let the product temperature de-
crease to room temperature before
storage.
Many products are stored at the
same time. Store less products at the same
time.
The temperature in the re-
frigerator is too high. There is no cold air circulation in
the appliance. Make sure that there is cold air circu-
lation in the appliance.
The temperature in the
freezer is too high. Products are too near to each oth-
er. Store products so that there is cold
air circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not set
correctly. Set a higher temperature.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
Remove the screw
from the lamp cover.
Remove the lamp
cover (refer to the il-
lustration).
Replace the used
lamp with a new lamp
of the same power
and specifically de-
signed for household
appliances (the maxi-
mum power is shown
on the lamp cover).
Install the lamp cover.
Tighten the screw to
the lamp cover.
Connect the plug to
the mains socket.
Open the door. Make
sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
21
www.zanussi.com