Xylem IM 28 ACT 909 Tankless Mounting Bracket Instructions (obsolete) - Manual

Installation & Instructions for Instant Hot Water Recirculating Systems
ACT 909 Tankless Mounting Bracket Instructions
Installation, Operation and Service Instructions
Laing Thermotech
Instruction Manual IM-28
Lift timer cover on the pump, and slide the switch to the “Off”
position. Turn off the water using the angle stop valves under
your sink. Unplug the pump, and disconnect the hoses from the
pump housing (Bronze top).
*Please note : For a currently installed pump, begin with figure 1. For an uninstalled pump begin with figure 5.
fig. 1
Using an Allen wrench, remove one of the bolts that connects
the pump motor drive unit to the housing.
fig. 2
Place the bolt through the bracket ear.
fig. 3
Screw the bolt with the bracket ear back into place, and
tighten. Repeat steps 2 through 4 on the other bolt. (DO ONE
SIDE AT A TIME ONLY, DO NOT REMOVE BOTH BOLTS AT THE
SAME TIME).
fig. 4
Locate the 4 rubber grommets.
fig. 5
Place the grommets in the side holes of mounting bracket.
fig. 6