AEG F34030VI0 - Manual (Page 32)

Problem Possible cause Possible solution
The quantity of detergent
was too much. Make sure that you add the
correct quantity of deter-
gent in the dispenser be-
fore you start a programme.
Dry water drop
stains on glasses
and dishes. The released quantity of
rinse aid was not suffi-
cient . Increase the released quan-
tity of rinse aid.
The quality of the deter-
gent can be the cause. Try a different brand of de-
tergent.
The dishes are wet. The programme had no
drying phase. Set a programme with the
drying phase.
The dishes are wet
and matt. The rinse aid dispenser is
empty. Make sure that there is rinse
aid in the rinse aid dispens-
er.
The quality of the rinse aid
can be the cause. Try a different brand of
rinse aid.
10. TECHNICAL INFORMATION
Dimensions Width / Height / Depth
(mm) 596 / 818-898 / 555
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2) max. 60 °C
Capacity Place settings 12
Power consumption Left-on mode 0.99 W
Off-mode 0.10 W
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
11. ENVIRONMENT CONCERNS
Recycle the materials with the
symbol . Put the packaging in
applicable containers to recycle it. Help protect the environment and
human health and to recycle waste
of electrical and electronic
appliances. Do not dispose
32 www.aeg.com