Acer V176L - Manual (Page 19)

En
g
lis
h
Installation
To install the monitor on your host system, please follow the steps below:
Steps
1 Connect the video cable
a
Make sure both the monitor and computer are switched off.
b Connect the VGA video cable to the computer.
c Connect the digital cable (only for dual-input models).
(1) Make sure both the monitor and computer are switched off.
(2) Connect one end of the 24-pin DVI cable to the back of the
monitor and the other end to the computer's port.
2 Connect the power cord
Connect the power cord to the monitor, then to a properly grounded AC
outlet.
3
Turn on the monitor and computer
Turn on the monitor first, then the computer. This sequence is very
important.
If the monitor does not function properly, please refer to the
troubleshooting section to diagnose the problem.
5
e
AUDIO IN POWER VGA IN DVI-D IN
DVI
D-Sub
AUDIO IN VGA IN DVI-D IN