Zanussi ZFU420FW - Manual (Page 16)

Problem Possible cause Solution
The appliance has no power. There is
no voltage in the mains socket.
Connect a different electrical appliance
to the mains socket.
Contact a qualified electrician.
The Pilot light flashes. The appliance is not working properly. Contact a qualified electrician.
The Alarm light flashes. The temperature in the freezer is too
high.
Refer to "Excessive Temperature Alarm"
The compressor operates contin-
ually.
The temperature is not set correctly. Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too fre-
quently.
Do not keep the door open longer than
necessary.
The product temperature is too high. Let the product temperature decrease to
room temperature before storage.
The room temperature is too high. Decrease the room temperature.
The Fast Freeze function is switched
on.
Refer to "Fast Freeze function".
The temperature in the freezer is
too low.
The temperature regulator is not set
correctly.
Set a higher temperature.
The Fast Freeze function is switched
on.
Refer to" Fast Freeze function".
The temperature in the freezer is
too high.
The temperature regulator is not set
correctly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too high. Let the product temperature decrease to
room temperature before storage.
Many products are stored at the same
time.
Store less products at the same time.
Products are too near to each other. Store products so that there is cold air
circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not set
correctly.
Set a higher temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
16