Acer B273PHL - Manual (Page 15)

EN-14
INSTALLATION
To install the monitor to your host system, please follow the steps as given
below:
Steps
1. 1-1 Connect Video Cable
a. Make sure both the monitor and computer are powered-OFF.
b. Connect the VGA video cable to the computer.
1-2 Digital Cable (Only Dual-Input Model)
a. Make sure both the monitor and computer are powered-OFF.
b. Connect one end of the 24-pin DVI cable to the back of the
monitor and connect the other end to the computer’s port.
1-3 Connect DP Cable (Only DP -Input Model)
a. Make sure both the monitor and computer are powered-OFF.
b. Connect the cable to the computer.
2. Connect the Audio Cable(Only Audio-Input Model)(Optional)
3. Connect the USB Cable(Only USB-Input Model)(Optional)
4. Connect power cord
Connect the power cord to the monitor, then to a properly grounded AC
outlet.
5. Power-ON Main power switch
6. Power-ON Monitor and Computer
Power-ON the monitor first, then power-ON the computer.
This sequence is very important.
7. If the monitor still does not function properly, please refer to the
troubleshooting section to diagnose the problem.
Main power switch
DP
Connect