Dp mode selection – Acer B276HUL User Manual
Page 26
EN-17
Adjusting the setting
1 Press the MENU key to bring up the OSD.
2 Using the / keys, select
Setting from the OSD. Then navigate to
the feature you wish to adjust.
3 The Setting menu can be used to adjust the screen Menu Language and
other important settings.
4 Select Power-off USB charge ON/OFF to enable/disable Power-off USB
charge function.
5.
Select PIP to adjust picture‐in‐picture settings. The PIP signal
source needs to
be selected manually. The table below shows the active
input combinations for PIP.
PIP On & Input status
PIP
Main
DVI
HDMI1
HDMI2
DP
DVI
x
x
x
v
HDMI1
x
x
x
v
HDMI2
x
x
x
v
DP
v
v
v
x
x
: Does not support PIP function in this combination
DP mode selection
The default out of DP signal setting in the B276HUL is DP1.2. User can
follow the setting message
to
confirm
selection
of
DP1.2
or
DP1.1
6
7
When using PIP, "Wide mode", "6-axis Saturate", "6-axis Hue", "ACM"
and "Detect Video" will be enabled for the main source display.
"Wide mode" is not supported when using PBP function.
8