Hotpoint Ariston FK 892EJ P.20 X-HA - Manual (Page 29)

29
GB
D
To activate the Fast Clean programme:
1. Switch the control panel on by pressing the
button.
2. Press button ; the display will show the text
“Piro”, “nor” and the default duration of 1:30 h
(normal cycle) alternately.
3. Press button , then turn the TIMER knob to
adjust the default cleaning level. There are 3
different levels to choose from, each with a pre-set
duration which cannot be modified:
1. Economy (ECO): turn the knob towards “-”.
Duration 1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30
minutes.
3. Intensive (INT): turn the knob towards “+”.
Duration 2 hours.
4. Press the button to confirm.
5. Press the button to begin the cleaning cycle.
An end time for the FAST CLEAN cycle (as for a
normal cooking cycle) may be programmed (see
Programming the automatic cleaning end time).
Safety devices
• the door locks automatically as soon as the
temperature reaches a high value; the icon
lights up on the display;
• pressing the button cancels the cleaning
cycle at any time;
• if a malfunction occurs, the heating elements will
be switched off;
• once the oven door has been locked, you cannot
change the duration and end time settings.
Programming the automatic cleaning end time
1. Press the button twice: the icon and the
numerical digits on the display will begin to flash.
2. Turn the TIMER knob towards “+” and “-” to
adjust the cleaning end time value.
3. Once you have reached the desired end time,
press the button again. The display will show
the duration, the cleaning end time and the set
cleaning level alternately.
4. Press the button to activate the programmed
mode.
Programming has been set when the and
buttons are illuminated.
2. Choose which shelf
to use with the sliding
rack. Paying attention
to the direction in which
the sliding rack is to be
extracted, position joint
B and then joint C on
the frame.
3. Secure the two
frames with the guide
rails using the holes
provided on the oven
walls (see diagram).
The holes for the left
frame are situated at
the top, while the holes
for the right frame are
at the bottom.
4. Finally, fit the frames on the spacers A.
! Do not place the sliding racks in position 5.
Automatic cleaning with the FAST
CLEAN function
With the FAST CLEAN mode, the internal
temperature of the oven reaches 500°C. The
pyrolytic cycle is activated, burning away food and
grime residues. Dirt is literally incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause for
concern: this process is both normal and hazard-free.
Before initiating the FAST CLEAN mode:
• clean the oven door;
• remove large or coarse food residues from the
inside of the oven using a damp sponge. Do not
use detergents;
• remove all accessories and the sliding rack kit
(where present);
• do not place tea towels or pot holders over the
oven handle.
! If the oven is too hot, the pyrolytic cycle may not
start. Wait for the oven to cool down.
! The programme may only be started once the oven
door has been closed.
B
C
Left
guide rail Right guide
rail
Direction
of extraction