AEG HK764403FB - Manual (Page 27)

The heat setting
Touch the control bar at the heat setting. Change
up or down, if it is necessary. Do not release be-
fore you have a correct heat setting.
Bridge function
The Bridge function connects two cooking zones and they operate as one.
First set the heat setting for one of the cooking zone.
To activate the Bridge function for left/right cooking zones touch / . To set or change
the heat setting touch one of the left/right control sensors.
To deactivate the Bridge function touch / . The cooking zones operate independently.
Automatic Heat Up
1
2
3
4
5
6
7
8
9
10
11
12
0
1 2 3 4 5 6 7 8 9 10 11 12 13 14
You can get a necessary heat setting in a shorter time if you activate the Automatic Heat
Up function. This function sets the highest heat setting for some time (see the illustration),
and then decreases to the necessary heat setting.
To start the Automatic Heat Up function for a cooking zone:
1.
Touch ( comes on in the display).
2. Immediately touch the necessary heat setting. After 3 seconds comes on in the dis-
play.
To stop the function change the heat setting.
Power function
The Power function makes more power available to the induction cooking zones. The Power
function is activated for 10 minutes at most. After, that the induction cooking zone auto-
Operating instructions 27