English, Multi-purpose trimmer for hair and face – Babyliss E830XE X-8 User Manual
Page 6
6
MULTI-pUrpOSE
TrIMMEr FOr HAIr
AND FACE
1. 32mm blades
Moveable blade:
- Exclusive
three-dimensional
etching
process:
for
an
exceptionally sharp cutting
edge.
- CMS
(Chrome-Molybdenum-
Stainless
Steel):
ultra-
hardwearing and 100% stainless
steel blade.
Fixed Blade: Stainless steel
2. 2 cutting guides (2-14mm
and 3-15mm) for hair and
beard
3. 6-position precision guide
(from 0,5 to 3mm) for very
short cuts
4. 18mm shaving head for face
5. 7mm precision blade, to
create precisely contours and
original designs
6. Nose/ear
accessory,
to
eliminate unwanted nose and
ear hair
7. On/Off switch
8. Charging indicator light
9. Cleaning brush
10. Charging and storage base
IMpOrTANT
INFOrMATION
rEGArDING
THE
NI-MH
BATTErIES OF THIS UNIT
To obtain and maintain the
longest
battery
autonomy
possible, allow it to charge
for 16 hours before using it
for the first time and then
approximately every three
months. Full autonomy of the
unit will only be obtained after
three complete recharge cycles.
CHArGING THE UNIT
Before using the trimmer for the
first time, allow it to charge for
16 hours.
1. Remove the trimmer and all
the accessories from the base
and turn the base over. Open
the security tongue, insert the
power cord into the opening
intended for this, pushing it in
firmly and replace the security
tongue. Place the cord in the
groove. Put the base back in
place and connect it to the
mains. (Fig. 1)
2. Place the trimmer (set to OFF)
in the charging base and check
that the charging indicator
light is on.
3. A full charge will allow you 30
minutes of autonomous use.
WATErprOOF
For a greater comfort of use, your
E830XE trimmer is waterproof and
can even be used in the shower.
Easy to clean, it guarantees a
maximum hygiene.
ATTACHING AND rEMOVING
ACCESSOrIES
Make sure that the unit is
switched off before changing the
trimmer head or accessories.
To attach a head, fit the base
of the accessory onto the unit
pressing it until you hear a click.
To remove a head, hold the handle
of the unit in one hand and push
up on the head with your free
hand to remove it (Fig.2).
USING THE CUTTING GUIDES
Very practical, the cutting guide
guarantees equal cutting length.
IMPORTANT: Always attach the
cutting guide BEFORE turning
ENGLISH