Babyliss ST100E 230 elegance - Manual (Page 5)

5
Temp. Hair type
•
Fine, lightened
and/or
damaged hair
• •
Normal,
coloured and/
or wavy hair
• • •
Thick and/or
curly hair
• The red flashing indicator light:
after a very brief heat-up time,
your straighteners are ready to
use; the red LED stays on, the
blue LED indicates the ionic
function of your straighteners.
• Take a section of hair about 2 to
3 cm wide and place it between
the 2 heating plates close to the
roots.
• Press the handles of the
straightener, grip the straightener
tightly to hold the section and
slide it slowly from the roots to
the ends. Repeat if necessary,
then release the handles.
• Take a new section and repeat
until you have straightened all of
your hair.
Note! Every time you use the
straightener, there might be a
little smoke. This could result from
evaporating sebum or the remnants
of hair products (leave-in hair care,
spray, etc.) or damp hair.
• Give your hair the final touch.
Set the style with a light mist of
hairspray or a small amount of
mousse, but do not brush your
hair.
• After use, press the ‘O’ button
and unplug the straightener.
To shape your hair
The BaByliss 230 elegance
straightener can also be used to
accent certain sections of hair (to
straighten the fringe or create a
tousled look, etc.)
• To style your hair with the
ends curling under, follow the
above instructions but turn the
appliance inwards (as you would
with a brush when blow-drying).
Hold in place for a few seconds,
then release.
• To have the ends curl out, use the
same movement but turn the
straightener outward.
MAINTENANCE
• Unplug the straightening iron
and allow to cool completely.
• Clean the plates using a soft,
dampened cloth, without soap,
to preserve the optimal quality
of the plates. Do not scratch the
plates.