AVSL 499.920 STANDARD METAL DETECTOR - Manual (Page 7)

- 38 -
Læs først hele denne vejledning og gem den for senere brug.
Denne metaldetektor kan bruges til at finde mange forskellige slags
metaller, f.eks. mønter og smykker af guld eller sølv. Den er udstyret med
et drejespole-instrument til bestemmelse af metal-type samt batteri-
indikation. Den har desuden mulighed for tilslutning af øresnegl, vandtæt
søgespole og teleskopskaft. Bruger 6 stk. 1,5V penlight (AA) batterier. (Lev.
uden batterier)
HUSK at følge gældende regler for hittegods samt
indhente fornøden tilladelse hvis “skattejagten” foregår på
privat område.
FORBEREDELSE TIL BRUG.
INDSTILLING AF TELESKOPSKAFT.
4.
Løsn den sorte omløber ved at dreje den venstre om.
5. Skyd skaftet ud så søgespolen kan holdes 2 – 5 cm over jorden
uden at man skal gå foroverbøjet.
6. Stram omløberen igen ved at dreje den højre om.
INDSTILLING AF SØGESPOLE.
Søgespolens forskruening løsnes så den kan vippes til en vinkel parallelt
med jordens overflade og skruen strammes igen.
- 7 -
As you search, you can fine-tune the detector using DISCRIMINATION
(see “Fine-Tuning the Detector” on Page 5).
Note: Press the red button on the handle at any time during operation to
automatically return the pointer to 0.
TESTING AND USING THE DETECTOR
To learn how the detector reacts to different metals, you should test it
before you use it the first time. You can test the detector indoors of
outdoors.
Indoor Testing
1. Remove any watches, rings, or other metal jewelry you are wearing, then
place the detector on a wooden or plastic table.
2. Adjust the search coil’s angle so the flat part faces the ceiling.
Note: Never test the detector on a floor inside a building. Most buildings
have metal of some kind in the floor, which might interfere with the
objects you are testing or mask the signal completely.
3. Rotate VOLUME to the 11 o’clock position.
4. Set DISCRIMINATION to its midpoint.
5. Move a sample of the material you want the detector to find (such as a
gold ring or a coin) about 2 inches above the search coil.
Notes:
The search coil will not detect without motion. You must move the
object since you are not sweeping with the detector at this time.
If you are suing a coin, the detects it more easily if you hold it so a flat
side is parallel with the flat side of the search coil (not the edge).
If the detector detects the material, it sounds a tone and the pointer moves
to the left (ferrous) or to the right (non-ferrous) while the detector
determines the type of meal it is detecting.