AVSL 171.848 VGW1 - Manual (Page 4)

SPECIFICATIONS
Carrier type VHF 174.1MHz (UK or AU), 198.25MHz (EU)
Frequency stability ±0.005%
Maximum deviation ±30kHz
Audio frequency response 40Hz – 20kHz
Signal to noise ratio >85dB
Audio dynamic range >80dB
T.H.D. ≤0.2%
Maximum range 50m
Operating temperature -10ºC to +50ºC
RECEIVER
Power supply 12Vdc 300mA (mains adapter supplied)
Audio outputs XLR (balanced), Jack (unbalanced)
Controls Power On/Off, Output volume
Indicators Power, Signal (RF)
Dimensions 43 x 213 x 180mm
Weight 340g
BELTPACK TRANSMITTER
Battery 9Vdc, PP3
Switch Power / Mute / On
Connector 6.3mm to 3.5mm mono jack lead (supplied)
RF emission <10mW
Dimensions 105 x 60 x 30mm
Weight (without battery) 77g
Troubleshooting
“POWER” LED does not light on receiver
Ensure power adapter is connected to mains and working properly
Ensure receiver is switched on
“POWER” LED is lit but no “SIGNAL” LED
Ensure transmitter is switched on
Check that transmitter is not out of reception range
Check that transmitter battery is good / charged
LEDs are lit but no sound from microphone
Check if transmitter switch is in “MUTE” position
Check that the guitar volume controls are turned up
Make sure receiver is connected to amplifier
Make sure that amplifier volume is turned up
Ensure transmitter has a good / charged battery
Check if there is another nearby transmitter with the same frequency
Clean guitar output is very loud or distorted
Turn down GAIN ADJUST on beltpack transmitter
Turn down VOLUME on receiver
Microphone output is very low
Turn up GAIN ADJUST on beltpack transmitter
Turn up VOLUME on receiver
Increase Gain on amplifier
Turn up guitar volume controls
Check transmitter battery
Note: for further troubleshooting, refer equipment to qualified service personnel for testing
© Chord 2011