AVSL 171.864-171869 RU2 User Manual

Page 5

171.864 - 171.869 User Manual

Specifications

Power supply (receiver)

12 - 18Vdc 350mA adaptor (supplied)

Batteries (transmitters)

4 x AA (included)

Carrier frequency (171.864, 171.866, 171.868)

863.3MHz + 864.3MHz

Carrier frequency (171.865, 171.867, 171.869)

863.8MHz + 864.8MHz

Stability

10PPM

S/N ratio

>105dB

THD

<0.5% @ 1KHz

Image rejection

85dB typical

Range

60m (max)

Output impedance

2.2k ohms

Output level

Balanced: 0-400mv, unbalanced: 0-200mv

Connectors

DC in, 4 x XLRM, 6.3mm jack

Dimensions - handheld transmitter

243 x 48mmØ

Dimensions - bodypack transmitter

205 x 68 x 25mm

Dimensions - receiver

483 x 44 x 225mm

Weight - handheld transmitter

238g (no battery)

Weight - bodypack transmitter

76g (no battery)

Weight - receiver

2.15kg

Troubleshooting

“POWER” LED does not
light on receiver

Ensure power adapter is connected to mains and working properly
Ensure receiver is switched on

“POWER” LED is lit but
no “RF” or “AF” LEDs

Ensure transmitter is switched on
Check that transmitter is not out of reception range
Check that transmitter batteries are good / charged

“POWER” and “RF”

LEDs are lit but no
“AF” and no sound

Check that transmitter switch is not in “MUTE” position
Ensure transmitter has good / charged batteries
Ensure there is no other nearby transmitter with the same frequency

All LEDs lit but no
sound from mic

Make sure receiver is connected to mixer / amplifier
Ensure that receiver and amplifier/mixer channel volumes are turned up

Microphone output is

very loud or distorted

Turn down VOLUME on receiver
Turn down Gain on bodypack transmitter
Reduce Gain on mixer / amplifier
Ensure that XLR output is not fed to a Line input

Microphone output is

very low

Turn up VOLUME on receiver
Turn up Gain on bodypack transmitter
Increase Gain on mixer / amplifier
Ensure that Jack output is not fed to a Mic input
Check transmitter batteries

1622

DISPOSAL: Please dispose of the unserviceable device according to the current statutory requirement

Errors and omissions excepted.