AVSL 953.122 RS SERIES - Manual (Page 6)

RS Series User Manual
Operation
When all connections to the amplifier are made, turn the MASTER volume control (1) fully down and
switch on the power (3) and the power LED will illuminate.
Ensuring that the signal is active on the SLAVE IN inputs, turn up the MASTER gradually to the
maximum required volume level.
The output of the amplifier is represented on the SIGNAL LED and when the amplifier is running at
its peak output, a PEAK LED will illuminate.
Care should be taken that the Red PEAK LED is only lit momentarily during use.
Anything longer than a short flash of this LED may be indicating distortion or clipping of the output
signal and the MASTER volume should be turned down.
Powering down
To avoid loud pops through the speakers, turn down the MASTER control before powering down.