AVSL 172.035 PRO-SERIES - Manual (Page 4)

PRO240/480/600/1000 User Manual
Specifications
PRO240 PRO480 PRO600 PRO1000
Power supply 230Vac, 50Hz
Fuse rating T2A/T4A (240V/110V) T5A (240V) / T10A (110V)
Power max: 4Ω 2 x 120W 2 x 240W 2 x 300W 2 x 500W
Power rms: 4Ω 2 x 60W 2 x 120W 2 x 150W 2 x 250W
Power rms: 8Ω 2 x 40W 2 x 80W 2 x 100W 2 x 160W
Freq.response 20Hz - 20kHz
Input connectors 2 x RCA / 2 x 6.3mm jack
Input sensitivity 775mV, 10k ohms
Min. impedance 4Ω
Speaker outputs SPK connectors / 6.3mm jacks / 4mm Binding Posts
S/N ratio >98dB
THD <0.5%
Dimensions 482 x 240 x 88mm 482 x 300 x 88mm 482 x 300 x 88mm 482 x 380 x 88mm
Weight 5.2kg 6.45kg 7.35kg 9.0kg
Troubleshooting
No power light on front
panel switch
Ensure IEC inlet is connected to mains and lead is in good condition
Ensure mains outlet is switched on
Power light is on but no
other LEDs and no output
Check input signal and connection leads
Ensure channel gain controls are not turned fully down
Power light and Signal
LEDs are lit but no output
Check speakers are in good working order and not shorted (use a multi-tester)
Check speaker leads are in good condition and connected properly
If speakers/leads OK, switch off again and refer to qualified service personnel
Case getting hot Ensure cooling vents are clear and fan is working (refer to technician if not)
Output is very distorted
and “CLIP” LEDs are
lighting
Check the speaker impedance is not below rated Ohms
Turn down the input level from audio source
Turn down channel gain controls
Output is working but at
very low level
Ensure input source is at line level
Increase input level from audio source
Turn up channel gain controls
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd.
Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.