beautypg.com

Arnott generation ii rear air spring for, Bravada/envoy/rainier/trailblazer/saab 9-7 – Air Suspension A-2610 REV 2 User Manual

Page 2

background image

2

A-

2610

ARNOTT GENERATION II

REAR AIR SPRING FOR

2002-2009

BRAVADA/ENVOY/RAINIER/TRAILBLAZER/SAAB 9-7

A-2610

REV 2

03/07/2014

AIR SPRING REMOVAL

1.

SET STEERING TO STRAIGHT AHEAD.


2.

RAISE VEHICLE.

3.

REMOVE REAR WHEEL.

4.

LOCATE THE AIR COMPRESSOR BEHIND THE RIGHT REAR WHEEL.

5.

REMOVE THE TWO LOWER MOUNTING BOLTS FROM THE COMPRESSOR MOUNTING PLATE. LIFT UPWARD

ON THE COMPRESSOR ASSEMBLY AND UNHOOK THE UNIT FROM THE FRAME RAIL.

6.

DEFLATE REAR AIR SPRING AND PULL DOWNWARD TO REMOVE IT FROM THE AXLE. THE AIR SPRING IS

HELD FROM TURNING WITH A PLASTIC CLIP ON THE TOP OF THE AIR SPRING. YOU MAY HAVE TO HOLD THE

PLASTIC CLIP DOWN WHILE ROTATING THE AIR SPRING TO FREE IT FROM THE UPPER SPRING SEAT.

7.

DISCONNECT THE AIR LINE FROM THE AIR SPRING BY PRESSING DOWN ON THE STEEL FITTING WHILE

PULLING OUTWARD ON THE AIR LINE.

8.

CAREFULLY REMOVE AIR SPRING FROM THE VEHICLE.

9.

SEAL OFF AIR LINE TO PREVENT ANY DIRT OR GREASE FROM ENTERING SYSTEM.

GENERAL INFORMATION:

Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement,

the full text of which is available at www.arnottinc.com.

• Not to be stored below 5

o

F (-15

o

C) and above 122

o

F (50

o

C).

• Avoid damage to air lines and cables.
• Removal and installation is only to be performed by fully qualified personnel.
• Use car manufacturer’s diagnostic software.

CAUTION:

Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified

in the instructions or in a different sequence.

To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to

disconnect your battery.

Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for

additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath

the vehicle if it is not adequately supported, as serious injuries and death can occur.