beautypg.com

Arnott bilstein front shock kit for, Audi allroad – Air Suspension SK-2716 REV 1 User Manual

Page 2

background image

2

REV 1

12/12/2013

SK-2716

SK-

2716

ARNOTT BILSTEIN FRONT SHOCK KIT

FOR

2001-2006

AUDI ALLROAD

AIR STRUT REMOVAL

1.

SET STEERING TO STRAIGHT AHEAD.

2.

RAISE VEHICLE.

3.

REMOVE FRONT WHEEL.

4.

BEGIN BY FIRST REMOVING THE LOWER SHOCK RETENTION NUT AND BOLT. (FIGURE A)

Consult your vehicles owners manual, service manual, or car dealer for the correct jacking points on your vehicle and for

additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath

the vehicle if it is not adequately supported, as serious injuries and death can occur.

To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to

disconnect your battery.

FIGURE A

GENERAL INFORMATION:

Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement,

the full text of which is available at www.arnottinc.com.

• Not to be stored below 5

o

F (-15

o

C) and above 122

o

F (50

o

C).

• Avoid damage to air lines and cables.
• Removal and installation is only to be performed by fully qualified personnel.
• Use car manufacturer’s diagnostic software.

CAUTION:

Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified

in the instructions or in a different sequence.