Asus RT-N10 (VER.D1) - Manual (Page 19)

1
3 Configuring the network clients
Accessing the wireless router
To access the ASUS Wireless Router, you must have the correct
TCP/IP settings on your wired or wireless clients. Ensure that
the clients’ IP addresses are within the same subnet as the ASUS
Wireless Router.
Setting up an IP address for wired or wireless clients
By default, the ASUS Wireless Router uses DHCP to automatically
assign IP addresses to the clients in your network.
You may, however, want to manually assign static IP addresses
on some of the clients or computers in your network rather than
automatically getting IP addresses from your wireless router.
Follow the instructions below that correspond to the operating
system installed on your client or computer.
In Router mode, if you want to manually assign an IP address
to your client, we recommend that you use the following
settings:
• IP address: 1.168.1.xxx (xxx can be any number between
and 4. The IP address should not be used by another device)
• Subnet Mask: ...0 (same Subnet Mask as the ASUS
Wireless Router)
• Gateway: 1.168.1.1 (IP address of the ASUS Wireless Router)
• DNS: 1.168.1.1 (ASUS Wireless Router) or assign a known
DNS server in your network.