AEG F35400IM0 - Manual (Page 25)

5.3 Filling the rinse aid dispenser
M AX
1 2 3
4 + -
A B
D
C
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between
position 1 (lowest quantity) and
position 4 (highest quantity).
6. DAILY USE
1. Open the water tap.
2. Turn the programme knob until the
programme marker is aligned with
the programme you want to set.
Make sure that the appliance is in
setting mode. Refer to ’SETTING
AND STARTING A PROGRAMME’.
Set the correct programme for the
type of load and the degree of soil.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Start the programme.
6.1 Using the detergent
20
30
M AX
1 2 3 4
+ -
A B
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
6.2 Combi detergent tablets
These tablets contain detergent, rinse
aid and other added agents. Be sure
that these tablets are applicable to the
water hardness in your area. Refer to the
instructions on the packaging of the
products.
When you use tablets, that contain salt
and rinse aid, do not fill the salt contain-
er and the rinse aid dispenser. The rinse
aid indicator always comes on if the rinse
aid dispenser is empty.
1. Adjust the water softener to the low-
est level.
ENGLISH
25