Asus DRW-0804P - Manual (Page 12)

12 ASUS DRW-0804P DVD ± R/RW drive
Rear panel
1. Audio output
This connector is for an analog audio output cable. This connector is
compatible with “Molex 70553”.
Pin Name Description
1 L Left channel audio output
2 & 3 G Ground
4 R Right channel audio output
2. Device configuration jumper
These pins allow you to select either Master, Slave, or Cable Select
mode for the drive. (
Refer to page 14 for the jumper settings )
Pin Name Switch Status Description
1 MA ON Master mode
2 SL ON Slave mode
3 CS ON Cable select mode
4-5 Reserved
3. Air vent
This air vent allows air intake to maintain ideal drive temperature.
Make sure the air vent is not blocked by cables or other objects inside
the system.
4. Host IDE interface
This connector is for a 40-pin IDE cable to connect the drive to the IDE
interface on the motherboard.
5. DC input
This DC connector is for a 4-pin power cable from the system power
supply.
1 2 5 3 4