Asus S1 - Manual (Page 13)

LED projector E-Manual 13
Emergency light mode
The LED projector flashes a blinking white light when you use this
feature.
To use your LED projector as a flashlight:
1. Disconnect all peripherals from your LED projector then press
the power button to turn it on.
. Open the cover of your LED projector's lens.
3. Press on the control panel of your LED projector to launch
the NO SIGNAL display.
4. Press repeatedly until the LED projector flashes a blinking
white light.
IMPORTANT! Ensure that your LED projector is charged and can run
on battery mode before enabling this feature. Battery time varies
depending on usage.
NOTE: To turn off or switch between the flashlight and emergency
light feature of your LED projector, just press the Splendid/Exit
button until your preferred lighting feature is disabled or enabled.
Splendid/Exit
button