Asus W2V - Manual (Page 46)

46
4
Using the Notebook PC
CAUTION: For electrical safety concerns, only use telephone cables rated 26AWG or
higher. (see Glossary for more information)
NOTE: When you are connected to an online service, do not place the Notebook PC in
suspend (or sleep mode) or else you will disconnect the modem connection.
WARNING! Only use analog telephone outlets. The built-in modem does not support
the voltage used in digital phone systems. Do not connect the RJ-11 to digital phone
systems found in many commercial buildings or else damage will occur!
Modem Connection
The telephone wire used to connect the Notebook PC’s internal
modem should have either two or four wires (only two wires
(telephone line #1) is used by the modem) and should have an
RJ-11 connector on both ends. Connect one end to the modem
port and the other end to an analog telephone wall socket (the
ones found in residential buildings). Once the driver is setup,
the modem is ready to use.
Telephone
Wall Jack
Telephone cables
with RJ-11 connectors
Telephone
connection is
optional
This is an example of the Notebook PC connected
to a telephone jack for use with the built-in modem.