Braun ER1373 Silk-épil SuperSoft Plus - Manual (Page 13)

13
1 Put on the shaver head by clicking
it in.
2 For shaving, set the switch to
position 3.
3 For best results, guide the shaving
system so that about half of the
foil and one of the trimmers are in
contact with your skin. The curved
trimmer first raises all long hairs
and cuts them off. Then the flex-
ible foil follows to smooth away
any stubble. The shaving system
gives you equal shaving action on
both trimmer sides, so you can
move it forwards and backwards
as you wish.
Cleaning and maintenance
of the shaver head
4 After every use, unplug the
appliance. To remove the shaving
system, push the release
button
è .
5 Tap the bottom on a flat surface.
6 Do not brush the foil surface in
order to avoid damaging it.
7 Oil the trimmers sparingly with
sewing machine oil at least every
3 months. Add some vaseline into
the left and right of the opening of
the shaving system.
8 Give the inside of the shaver head
housing a quick clean.
9 Click in the shaving system and
put on the protective cap.
Note: Do not shave with a damaged
foil. In such case, have the shaving
system replaced at a Braun Service
Centre.
Subject to change without notice.
This product conforms to
the EMC-Requirements as
laid down by the Council
Directive 89/336/EEC and to
the Low Voltage Regulation
(73/23 EEC).
B Shaving
5304166_ER1373_MN Seite 13 Montag, 3. April 2000 9:47 09