Cr100 universal remote control – Arcam FMJ DV139 User Manual

Page 8

DV139

E-8

��

��

��

��

�

��

CR100 Universal remote control

The CR100 remote control is a multi-function unit that controls the
DV139 and up to seven other devices. The instructions on this page
only refer to the control of the Arcam DV139.
For information on using the remote control for other devices, and
a full list of features, see the instruction booklet supplied with the
CR100.

Device selection
IMPORTANT: Press the ‘DVD’ button first to
operate the DV139.

On/Stand-by
This allows the DV139 to be put into and taken out
of stand-by remotely.

Navigation buttons
Arrow buttons allow navigation around the Basic
and Advanced Set-up menus on the DV139.
Confirm a selection by pressing

SHIFT

to Power on

SHIFT

to Power off

Numeric keys
Gives direct access to individual tracks on audio
CDs.

VOLUME +/–
Adjusts the sound output.

MODE
This button brings up a menu similar to the ‘Audio’
page of the Set-up menu and allows the Dolby
Pro Logic II settings to be changed while a disc
is being played. Cycles through available audio
surround modes.

SHIFT

MODE

cycles through HDMI settings.

DISP (display)
Press to cycle through the front panel display’s
brightness options (dim to bright, off).

Press and release to skip backwards to the
previous track(

) or forwards to the next track

(

RPT
Cycles through repeat play options (chapter, title,
disc, etc.).
Press

SHIFT

RPT

to repeat a specific section of a

DVD or VCD (an ‘A-B repeat’).

MENU
Activates the DVD menu if available.

RND
Toggles random (‘shuffle’) play of chapters/tracks
on and off.

Source selection and handset configuration

DVD

DVD input/DVD controls

SAT

Satellite decoder input/SAT controls

Television (sound) input/AV controls

TUN

Radio tuner input/TUN controls

AMP

Arcam amplifier

AUx

Auxillary (line) input/AUX controls

VCR

Video Cassette Recorder input/VCR
controls

CD player input/CD controls

Press the relevant button once to select input and
reconfigure the handset.
Press and hold the button until the power LED
blinks once if you wish to reconfigure the handset
without changing the input.

Advanced controls
These buttons are described on the next page.

MUTE
Press once to mute an Arcam amplifier. Press
again (or use

+/–

volume) to un-mute.

If the remote control receiver
(located on the right of the front-
panel window) is not ‘visible’ to the
remote control hand-set, then the
remote control will not work! Either
locate the unit differently, or take
advantage of the remote control
input on the rear of the player
(consult your dealer for further
information on this option).

Remember to install
the four AAA batteries
supplied before trying to
use your remote control.

This manual is related to the following products:

DV139