Braun cruZer6 beard&head EU - Manual (Page 10)

11
• Once the appliance is completely charged, discharge it through normal
use. Then recharge to full capacity. Subsequent charges will take about
1 hour (model cruZer5 beard: about 8 hours).
• A full charge provides up to 40 minutes of cordless operating time.
This may vary according to your beard growth.
• Maximum battery capacity will only be reached after several charging/
discharging cycles.
Charge Indicator (5)
Model cruZer6 beard&head:
• The charge indicator shows the status of the batteries.
• The charge indicator blinks green when the appliance is being charged.
When the battery is fully charged, the charge indicator shines permanently
green provided the appliance is connected to an electrical outlet.
• During cordless use the charge indicator blinks green.
• The charge indicator flashes red when the battery is running low. You
should be able to finish your current trimming sequence.
Model cruZer5 beard:
• The charge indicator shines permanently green provided the appliance is
connected to an electrical outlet.
Comb attachments
(1a, 1b)
• The combs can be taken off by pressing the release buttons (1c) with
your thumb and forefinger.
Beard trimming
• Place the beard comb (1a) on the appliance with the appliance turned off
(a).
• Press length selector (6) and slide the beard comb up to your desired
beard length (possible length settings: 1, 3, 5, 7, 9, 11 mm).
• It is advisable to begin with the highest setting and then reduce the
setting until you reach the desired beard length.
• Press the on/off switch (7). Hold the beard comb with the angled edge
against your beard and guide the trimmer against the direction of the hair
growth (a).
• To avoid clogging the beard comb with hair, clean it from time to time with
the brush.
99877212_beard-head_MN_S6-64.indd 11 99877212_beard-head_MN_S6-64.indd 11 21.03.11 10:22 21.03.11 10:22