Asus RS720-E6/RS12 - Manual (Page 85)

ASUS RS720-E6/RS12 5-21
The following item appears only when you set USB Function to [Enabled].
Legacy USB Support [Enabled]
Allows you to enable or disable support for legacy USB devices. Setting to [Auto]
allows the system to detect the presence of USB devices at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy
USB support is disabled. Configuration options: [Disabled] [Enabled] [Auto]
The following item appears only when you set USB Function to [Enabled].
USB 2.0 Controller Mode [HiSpeed]
Allows you to set the USB 2.0 controller to HiSpeed (480Mbps) or FullSpeed
(12Mbps). Configuration options: [FullSpeed] [HiSpeed]
BIOS EHCI Hand-Off [Enabled]
Enables or disables the BIOS EHCI hand-off support.
Configuration options: [Disabled] [Enabled]
Hotplug USB FDD Support [Auto]
Allows you to configure the Hotplug USB FDD support.
Configuration options: [Disabled] [Enabled] [Auto]
5.4.4 USB Configuration
BIOS SETUP UTILITY
Advanced
USB Configuration
Module Version - 2.24.3-13.4
USB Devices Enabled :
None
Legacy USB Support [Enabled]
USB 2.0 Controller Mode [HiSpeed]
BIOS EHCI Hand-Off [Enabled]
Hotplug USB FDD Support [Auto]
USB Mass Storage Device Configuration
Enables support for
legacy USB. AUTO
option disables
legacy support if
no USB devices are
connected.
USB Mass Storage Device Configuration
BIOS SETUP UTILITY
Advanced
USB Mass Storage Device Configuration
USB Mass Storage Reset Delay [20 Sec]
Device #1 JetFlash TS256MJF2A
Emulation Type [Auto]
Device #2 USB Hotplug FDD
Emulation Type [Auto]
Allows BIOS to Enable
or Disable Floppy
Controller.