Asus A8V-VM - Manual (Page 41)

1-9 ASUS A8V-VM
• We recommend that you connect a high-definition front panel
audiozmodule to this connector to avail of the motherboard high-
definition audio capability.
• If you want to connect a high-definition front panel audio module to
this connector, make sure the Audio Controller item in the BIOS is
set to [Enabled]. See page - for details.
9. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module
that supports either High Definition Audio or AC `97 audio standard.
Connect one end of the front panel audio I/O module cable to this
connector.
A8V-VM Analog Front Panel Connector
AC 97 audio
pin definition
AAFP
Back line out L
AGND
Line out_R Line out_L
Back line out R
NC
+5V
A
+5V
A
AGND SENSE2_RETUR
POR
T1 L
POR
T2 R
POR
T2 L
SENSE1_RETUR
SENSE_SEND
POR
T1 R
PRESENCE# GND
A8V-VM
R
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
A8V-VM Chassis Intrusion Connector
A8V -VM
R
CHASSIS
+5VSB_M
B
Chassis Signal GND
(Default)