Asus EI-102 - Manual (Page 5)

4
Installation
Please follow the steps below to install the PoE Injector:
1. Connect the
Data In port to an RJ-45 port in your switch or hub via an
Ethernet cable.
2. Connect the Data Out port with a PoE Splitter, PD (such as router,
Access Point...etc.) or PoE Hub via an Ethernet cable.
3. Plug the power cord of the PoE Injector to the wall power jack.
Technical Specification
The following table shows the technical specification of the PoE Injector.
Standard
IEEE802.3 10BASE-T
IEEE802.3u 100BASE-T
IEEE802.3af
Connector DC Out: Power pin: 4,5 (V+), 7,8 (V-)
Network Cable
10BASE-T: 2 pair UTP/STP Cat.3,4,5 cable
EIA/TIA-568 100-ohm (100m)
100BASE-TX: 2 pair UTP/STP Cat.5 cable
EIA/TIA-568 100-ohm (100m)
LED System: power (green)
Power Input Input Power: 100~240V, 50~60Hz, 0.3A
Output Power 48V DC, 0.3A
Operating environment 0˚C~40˚C; 90% Humidity (non-condensing)
Storage Temperature 0˚C~70˚C
Dimension 117mm x 60mm x 35mm (L x W x H)
EMI & Safety
FCC Class B, CE, UL, cUL, CE/EN60950,
VCCI, MIC, CCC