Asus P9D-MV - Manual (Page 92)

4-28 Chapter 4: BIOS setup
4.4.15 APM
Allows you to configure the Advance Power Management (APM) settings.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Specify what state
to go to when power
is re-applied after
a power failure (G3
state).
Restore AC Power Loss [Last State]
Power On By PCIE [Disabled]
Power On By RTC [Disabled]
EuP Ready [Disabled]
Restore AC Power Loss [Last State]
Allows you to set the state the system will go to after an AC power loss. Configuration
options: [Power Off] [Power On] [Last State]
Power On By PCIE [Disabled]
This allows you to enable or diasble the PCIE devices to generate a wake event.
Configuration options: [Disabled] [Enabled]
4.4.14 Runtime Error Logging Support
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Specify what state
to go to when power
is re-applied after
a power failure (G3
state).
Runtime Error Logging Support [Disabled]
Bits per second [115200]
This item only appears when you set the Console Redirection to [Enabled]. Selects serial port
transmission speed. The speed must be matched on the other side. Long or noisy lines may
require lower speeds. Configuration options: [9600] [19200] [38400] [57600] [115200]
Flow Control [None]
This item only appears when you set the Console Redirection to [Enabled]. Allows you to
set the flow control to prevent data loss from buffer overflow. Configuration options: [None]
[Hardware RTS/CTS] [Software Xon/Xoff]
Runtime Error Logging Support [Disabled]
Allows you to enable or disable the Runtime Error Logging Support. Configuration options:
[Disabled] [Enabled]
Advanced
Advanced