Asus P4S800-MX - Manual (Page 31)

ASUS P4S800-MX motherboard user guide 1-23
12. System panel connector (10-1 pin F_PANEL1)
This connector accommodates several system front panel functions.
P4S800-MX
P4S800-MX Front Panel Audio Connector
F_PANEL1
PLED- PWR PLED+
Ground
GND
Reset
IDE_LED+ IDE_LED-
Power LED
Reset SW
ATX Power
Switch*
IDE_LED
* Requires an ATX power supply.
P4S800-MX
P4S800-MX PLED Setting
PLED1
PLED+
1
NC
PLED-
11. Power LED Lead (3-1 pin PLED1)
This 3-1 pin connector is for the system power LED. Connect the 3-pin power
LED cable from the system chassis to this connector. The LED lights up when
you turn on the system power, and blinks when the system is in sleep mode.
The power LED lead (PLED1) is present only on PCB versions 1.03 or later.
• Power LED Lead (2-pin PWR_LED)
This 2-pin connector connects to the system power LED. The LED lights up when
you turn on the system power, and blinks when the system is in sleep mode.
If your motherboard package comes with a 2-pin to 3-pin power LED converter,
connect the 2-pin plug to this connector, and the other end to the 3-pin power
LED plug from the system chassis.