Hotpoint Ariston PFT 8H4X - Manual (Page 22)

22
EN
Shutting off the water and electricity
supplies
• Turn off the water tap after every wash cycle to avoid leaks.
• Always unplug the appliance when cleaning it and when
performing maintenance work.
Cleaning the dishwasher
• The external surfaces of the machine and the control panel
may be cleaned using a non-abrasive cloth which has been
dampened with water. Do not use solvents or abrasive
products.
• Any marks on the inside of the appliance may be removed
using a cloth dampened with water and a little vinegar.
Preventing unpleasant odours
• Always keep the door of the appliance ajar in order to avoid
moisture from forming and being trapped inside the
machine.
• Clean the seals around the door and detergent dispensers
regularly using a damp sponge. This will avoid food
becoming trapped in the seals, which is the main cause
behind the formation of unpleasant odours.
Cleaning the sprayer arms
Food residue may become encrusted onto the sprayer arms
and block the holes used to spray the water. It is therefore
recommended that the arms are checked from time to time
and cleaned with a small non-metallic brush.
The two sprayer arms may both be removed.
To remove the upper sprayer arm,
turn the plastic locking ring in an
anti-clockwise direction. The upper
sprayer arm should be replaced so
that the side with the greater
number of holes is facing upwards.
The lower sprayer arm can be
removed by pressing on the side
tabs and pulling it upwards.
Cleaning the water inlet filter*
If the water hoses are new or have not been used for an
extended period of time, let the water run to make sure it is
clear and free of impurities before performing the necessary
connections. If this precaution is not taken, the water inlet
could become blocked and damage the dishwasher.
Clean the water inlet filter at the tap outlet regularly.
- Turn off the water tap.
- Unscrew the end of the water inlet hose, remove the filter and clean
it carefully under running water.
- Replace the filter and screw the water hose back into position.
Cleaning the filters
The filter assembly consists of three filters which remove food
residues from the washing water and then recirculate the water. They
should be cleaned if you wish to achieve the best results in every
wash.
Clean the filters regularly.
The dishwasher should not be used without filters, or if the filter is
loose.
• After several washes, check the filter assembly and if necessary
clean it thoroughly under running water, using a non-metallic brush
and following the instructions below:
1.
1. 1. 1. 1. Turn the cylindrical filter C in an anti-clockwise direction and pull it
out (fig. 1).
2.
2. 2. 2. 2. Remove the cup filter B by exerting a slight pressure on the side
flaps (fig. 2).
3.
3. 3. 3. 3. Slide out the stainless steel plate filter A (fig. 3).
4.
4. 4. 4. 4. Inspect the trap and remove any food residue. NEVER REMOVE
the wash cycle pump (black detail)
(fig. 4).
After cleaning the filters, replace the filter assembly and fix
it in position correctly; this is essential for maintaining the
efficient operation of the dishwasher.
Leaving the machine unused for extended
periods
• Disconnect the appliance from the electricity supply and shut off
the water tap.
• Leave the door of the appliance ajar.
• When you return, run a wash cycle when the dishwasher is empty.
*
Only available in selected models.
4
1
3
Care and maintenance
2