AEG A51100HSW0 - Manual (Page 28)

Problem Possible cause Solution
Food placed in the appliance
was too warm
Allow food to cool to room tem-
perature before storing
The temperature of the room
that contains the appliance is
too high for efficient operation
Try to reduce the temperature in
the room where the appliance
stands
The High temperature
alarm light is on.
It is too warm inside the freezer Refer to "High Temperature
Alarm"
The cabinet has been recently
switched on and the tempera-
ture is still too high
Refer to "High Temperature
Alarm"
There is too much frost
and ice
Products are not wrapped prop-
erly
Wrap the products better
The lid is not shut properly or do
not close tightly
Check if the lid closes well and
the gaskets are undamaged and
clean
The temperature is not set cor-
rectly.
Set a warmer temperature
The water drainage plug is not
correctly positioned
Position the water drainage plug
in the correct way
The lid doesn't close com-
pletely
There is excessive frost Eliminate excess frost
The lid gaskets are dirty or sticky Clean the lid gaskets
Food packages are blocking the
lid
Arrange the packages in the right
way, see the sticker in the appli-
ance
The lid is difficult to open The lid gaskets are dirty or sticky Clean the lid gaskets
It is too warm in the
freezer
The temperature is not set cor-
rectly.
Set a lower temperature
The lid does not close tightly or
it is not shut properly
Check if the lid closes well and
the gasket is undamaged and
clean
Before freezing the appliance
was not precooled sufficiently
Pre-cool the appliance for
enough time
Large quantities of food to be
frozen were put in at the same
time
Wait some hours and then check
the temperature again. Next time
insert smaller quantities of food
to be frozen at any one time.
Food placed in the appliance
was too warm
Allow food to cool to room tem-
perature before storing.
Products to be frozen are placed
too closely to each other
Place the products in a way so
that cold air could circulate
among them
28 What to do if…