Dayton Audio DTA-1W Wireless Amplifier System - Manual (Page 2)

Specifications:
Power Output: 15 watts RMS x 2 into 4 ohms
Total Harmonic Distortion: 0.04% (9W @ 4 ohms)
Dynamic Range:
90 dB
Frequency Response:
20-20,000 Hz
Input
Impedance: 10k Ohms
Transmitting Frequency Range: 2.4 GHz (2400-2480 MHz)
Sample Rate:
44.1 KHz, 16-Bit
*Wireless Range: Up to 20 meters (66 ft.) line-of sight
(range may vary)
Electrical Requirements:
DTA-1AR (amplifier/receiver):
12 VDC, 2A
DTA-1T (transmitter): 9 VDC, 1A
Dimensions:
2" H x 6-1/8" W x 3-3/8" D (both units)
Weight:
2.2 lbs total, 1.1 lbs. each unit
Layout
1. DTA-1AR right speaker output
2. Power supply input (both units)
3. Stereo 3.5 mm audio input (both units)
4. DTA-1AR
5. Power on and volume control (both units)
For wireless use: Connect your source to the 3.5 mm input
on the DTA-1T. Connect your speakers (4 or 8 ohms) to the
DTA-1AR. Connect power included power supplies to the
DTA-1T and DTA-1AR. Turn both units on. The DTA-1T will
indicate power on with a blue LED, while the DTA-1AR will
indicate power on and wireless sync to the DTA-1T with a
green LED.
For wired use: Connect a local source is to the AUX input of
the DTA-1AR, the green LED will change from green to blue
and the local source will automatically override the wireless
connection.
Either volume control on the DTA-1T or DTA-1AR may be
used to control the volume level of the amplifier output.