Miele HS12 - Manual (Page 29)

Please observe the flooring
manufacturer's cleaning and care
instructions.
c Vacuum carpets and rugs with the
brush retracted (press foot control
%). Clean hard flooring which is not
susceptible to scratching with the
brush protruding (press foot
control
)).
Clean flooring which has deep
crevices or grooves with the brush
protruding.
Using the accessories
supplied (dia. 7 + 8)
The following accessories are supplied:
a Dusting brush
b Upholstery nozzle
c Crevice nozzle
d Accessories holder for the three
accessories supplied
There are symbols on the accessories
holder to show you where to postion the
accessories.
^ Attach the accessories holder pointing
upwards to the hose connector socket
or pointing downwards to the suction
hose where it joins the handle. Make
sure it clicks into position.
Depending on model, your vacuum
cleaner may be supplied with an Active
Air Clean filter or an Active HEPA filter
which can be fitted instead of the
standard Air Clean filter (see
"Maintenance and care - Replacing one
type of exhaust filter with another").
Floorhead (dia. 9)
For general use and also for vacuuming
stairs.
Warning: For safety reasons when
vacuuming stairs it is best to start at
the bottom of the stairs and move
upwards.
Use
Unwinding the cable (dia. 10)
a Pull the mains cable out to the
required length (max. approx. 5.5 m).
Warning: If vacuuming for longer
than 30 minutes, the mains cable
must be pulled out to its fullest
extent. Otherwise there is a danger
of overheating and damage.
Rewinding the cable
^ Switch the vacuum cleaner off at the
wall socket and unplug it.
b Press the rewind foot control briefly.
The cable will rewind automatically.
Switching on and off (dia. 11)
^ Press the On/Off foot control s.
en
29