QTech Data Systems Multi Point Controller (MPC) System User Manual
Page 6
QTech Multi Point Controller for WP2P - Quick Start Guide – v1 – August 2012
6
www.qtech.co.nz
Tel: 03 3663713
I/O Link Editor – Example 1 Simple
In this example, when the switch wired to input 1 of the Multi Point Controller is
closed, the following happens:
Multi Point Controller Output 1
On
WP2P Module 1 Output 1
On
WP2P Module 2 Output 2
On
WP2P Module 3 Output 3
On
The “Summary” pane on the right hand side shows a confirmation of the mapping.