SCANTECH ID (Champtek company) SG300RFM - Manual (Page 24)

20
Calculate Check Digit and
Transmit
Calculate Check Digit and
Not Transmit
>
Output Start / Stop Character
Enable Start/Stop Character
Character>
>
Decode Asterisk
Enable Decode Asterisk
The scanner will decode the
“*” symbol in code 39.
The scanner will not decode
the “*” symbol in code 39.
>
Setup Code Length
1. Scan the “Set Begin” Bar Code (2 Sets
Available)
2. Go to Decimal Value Table in Appendix A, scan
Bar Code(s) that represents the code length
3. Scan the “Complete” Bar Code
Repeat Steps 1-3 to set additional lengths
< Variable>
The output would be the