Program sequence – SCANTECH ID (Champtek company) IG300 User Manual
Page 7

4
3. Program Sequence
You can setup your device by scanning all necessary
programming codes for parameters that meet
applications. After these scan(s), the device is
automatically configured.
The Chapter 4 to 9 provides you with the
programming codes necessary for a basic setup. For
more advanced setup options, please see the User’s
Manual
3.1 Factory Default Settings
The default RS232 settings are 57600 baud, 8 data
bits, and no parity.
The factory default settings are shown with bold
< >
in the following pages.
By Scanning “Set factory default” code, the setting
will go back to the factory default setting. If you are
using a USB interface, your device will be lost USB
interface settings, please re-configure USB
parameter
Set factory default