Aqua-Pure AP802 - Manual (Page 6)

LIMITED WARRANTY
FILTER CARTRIDGE REPLACEMENT INSTRUCTIONS
Filter life depends on local water conditions and the volume of water used. We recommend you change your filter as pre-
scribed by the filter documentation. However, it can be replaced earlier if there is a drop in water pressure.
You can use a variety of cartridges with the AP800 Series housings: AP810, AP811, AP814, AP810-2, AP811-2 and
AP814-2 for particulate and rust; AP817, AP817-2 for particulate, chlorine taste & odor.
NOTE: Before changing cartridge, turn off main water supply. Place a bucket under filter to catch the small amount of
water that will run out after housing removal.
1. Turn off the water supply and close shut-off valve after filter head.
2. Relieve pressure in filter housing by pushing red vent button.
3. Unscrew housing (to the left) using housing wrench supplied with the product and discard old cartridge. Wash
housing thoroughly with mild soap and water.
4. Lubricate o-ring with water.
5. Insert new cartridge and re-install housing. Be sure cartridge is correctly installed and o-ring is seated on the hous-
ing before tightening onto head.
6. Turn on the water supply and shut off valve. Open main shut-off valve and check for leaks.
7. Vent air and check on leaks, tighten housing as needed with housing wrench supplied with the product. Open shut-
off valve after filter head.
8. Flush at least 10.5 gallons through system.
TROUBLESHOOTING GUIDE
Water Leaks at Fittings:
Tighten slightly until leak stops.
If Leaks Persist:
Shut off water at the main water supply shut-off valve, remove threaded fittings, reapply PTFE tape in a clockwise direc-
tion (to the right) and screw back onto head assembly.
CAUTION
To reduce the risk associated with property damage due to water leakage:
• The disposable cartridge must be replaced every 6 months, at the rated capacity or sooner if a noticeable reduction in flow rate occurs.
3M Purification Inc. warrants this Product will be free from defects in material and manufacture for ten (10) years) from the date of purchase. The filter
cartridge or filter membrane is warranted to be free from defects in material and manufacture for one (1) year. This warranty does not cover failures result-
ing from abuse, misuse, alteration or damage not caused by 3M Purification Inc. or failure to follow installation and use instructions. No warranty is given
as to the service life of any filter cartridge or membrane as it will vary with local water conditions and water consumption. 3M PURIFICATION INC. MAKES
NO OTHER WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OR CONDITION OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR ANY IMPLIED WARRANTY OR CONDITION ARISING OUT OF A COURSE OF DEALING,
CUSTOMER OR USAGE OF TRADE. If the Product fails to satisfy this Limited Warranty during the warranty period, 3M Purification Inc. will, at 3M
Purification Inc.’s option, replace the Product or refund your Product purchase price. This warranty does not cover labor. The remedy stated in this para-
graph is Customer’s sole remedy and 3M Purification Inc.’s exclusive obligation. For additional information, please call 1-800-222-7880.
This warranty gives you specific legal rights, and you may have other rights which may vary from state to state or country to country. For any warranty
questions, please call 1-800-222-7880 or mail your request to: Warranty Claims, 3M Purification Inc., 400 Research Parkway, Meriden, CT 06450. Proof of
purchase (original sales receipt) must accompany the warranty claim, along with a complete description of the Product, model number and alleged defect.
Limitation of Liability. 3M Purification Inc. will not be liable for any loss or damage arising from this 3M Purification Inc. product, whether direct, indirect,
special, incidental, or consequential, regardless of the legal theory asserted, including warranty, contract, negligence or strict liability. Some states and coun-
tries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
5
AP800 Series Replacement Cartridge Options
Particulate
Model
Load
Nominal Micron
Rating
Application
Max. Flow Rate
Particulate/Rust
Chlorine
Taste & Odor
AP810 Normal 5 • 20 gpm (75.7 lpm)
AP811 Medium 25 • 20 gpm (75.7 lpm)
AP814 Heavy 50 • 20 gpm (75.7 lpm)
AP817 Normal 25 • 10 gpm (37.9 lpm)
AP810-2 Normal 5 • 45 gpm (170.3 lpm)
AP811-2 Medium 25 • 45 gpm (170.3 lpm)
AP814-2 Heavy 50 • 45 gpm (170.3 lpm)
AP817-2 Normal 25 • 20 gpm (75.7 lpm)