SENA HelloDevice UniversalComm - Manual (Page 5)

5
3. Configuration of the communication mode
The Server Setting frame is composed of the following sections.
- Communication mode set-up section
- Communication parameter set-up section.
- Status bar and the command buttons
3.1 Frame layout
1) Communication mode check box
Specifies TCP/UDP or RS-232 communication mode
2) Parameter box
Specifies the Server port when users want to create server session, and Destination IP/
Destination Port to connect to the remote host
3) State box
Displays the current session status according to the communication mode specified
(Connected, Disconnected, Listening, Waiting Data, Open, Close)
4) [ Change Setting ] button
Available only when it is specified as RS-232 mode
Used in configuration of the serial communication parameters
5) Command button
Available operation is shown on the button according to the communication mode
specified. If pressed, the communication session will be created.
TCP
Client mode: [ Connect ] or [ Disconnect ]
Server mode: [ Listen ] or [ Stop Listen ]