AEG DL8590-M - Manual (Page 20)

20 EN
MAINTENANCE
REMOTE CONTROL
The appliance can be controlled using a remote control powered by
a 1.5 V carbon-zinc alkaline batteries of the standard LR03-AAA
type (not included).
• Do not place the remote control near to heat sources.
• Used batteries must be disposed of in the proper manner.
CLEANING THE COMFORT PANELS
• Pull the Comfort Panel to open it.
• Disconnect the panel from the hood canopy by sliding the fi xing
pin lever.
• The comfort panel must never be washed in a dishwasher.
• Clean the outside by using a damp cloth and neutral liquid de-
tergent.
• Clean the inside as well by using a damp cloth and neutral de-
tergent; do not use wet cloths or sponges, or jets of water; do
not use abrasive substances.
• When the above operation has been completed, hook the panel
back to the hood canopy and close it by turning the knob in the
opposite direction.
GREASE FILTERS
CLEANING METAL SELF- SUPPORTING GREASE FILTERS
Alarm signal reset
• Switch off the lights and extractor motor.
• Press button T3 for at least 3 seconds, until the leds start to
fl ash.
Cleaning the fi lters
• The
fi lters are washable and must be cleaned at least every 2
months of operation, or more frequently for particularly heavy
usage.
• Pull the Comfort Panel to open it.
• Remove
the fi lters one at a time by pushing them towards the
back of the group and pulling down at the same time.
• Wash the fi lters, taking care not to bend them. Allow them to
dry before refi tting.
• When refi tting the fi lters, make sure that the handle is visible on
the outside.