PolyPlanar ME60BT - Manual (Page 5)

ME60BT Bluetooth Amplifier 5
————————————————————————————
PO Box 409 Hanover, MD TEL (410) 761-4000 www.polyplanar.com
poly-planar
Marine Audio Systems
Wire Color Function
Red 1 B+ (+12VDC)
Green w/stripe 2 Rear Left Speaker-
Green
3 Rear Left Speaker+
BLANK 4 BLANK
White w/stripe 5 Front Left Speaker-
White
6 Front Left Speaker+
Blue 7 B+ (+12VDC)
Gray w/stripe 8 Front Right Speaker-
Gray 9 Front Right Speaker+
Black 10 Ground (Neg)
Violet w/stripe 11 Rear Right Speaker-
Violet
12 Rear Right Speaker+
Power Wire Specifications:
Red Wire and Blue Wire - Connect this two wires to a +12V.
Black Wire - Connect this wire to the negative battery terminal or other good
power ground.
Notes:
Use the included plug/wire bundle to connect to the power source and
speakers.
The Red, Blue and Black power wires should be 16AWG or larger
depending on the length to the battery. NEVER operate the unit without
the proper power and ground wire.
NEVER ground the speaker leads and NEVER allow the speaker leads to
come in contact with each other. The speaker wire should be at least 20
gauge or larger. Be sure to observe the correct polarity on the speaker
connections
Use quality crimp connectors to connect wires together. Seal the
connection well with electrical tape.
NEVER operate the unit without proper fusing. Fuse holder must be
located within 2 feet from the battery. This fuse is to protect the vessel,
not the electronics. In case of a short, the fuse will blow instead of the
wire burning up. Using other than the recommended fuse ratings at the
battery and at the unit may cause damage to the unit and will void your