PolyPlanar MRRF18 User Manual
PolyPlanar Remote control
MRRF18 INSTALLATION INSTRUCTIONS
1. Make sure the radio is turned off.
2. Connect the receiver module
’s 1/8
th
(3.5mm) jack
into the “IR connector” located at the back of the radio. Power will be supplied through the IR connection.
3. Keep the Antenna wire (long BLACK color wire) straight
and positioned away from any metal and power amps.
4. The Program wire (ORANGE color wire) does not
connect to anything. Systems will be pre-programmed at the
factory and no additional steps should be necessary. In
case your remote is not working, please follow instructions
below on how to re-program your remote. When programming a new remote, the radio needs to be connected to power and ground.
SPECIFICATIONS
RF Frequency -
433MHz
Antenna -
Internal
Functions -
1
– 18 Functions
Operating Temp - 0
– 70 Celsius
Environmental Conditioning - IP67, UV Resistant, Floating
Power Supply -
2 x 3Volt CR2032 Coin Cell Batteries
Code -
Digital Pulse
Battery Life -
12
– 15 Months Normal Use
Code Combinations -
4.294.967.295
Operating Range -
Up to 100’ (Will vary, dependent on installation)
Programming a new transmitter:
1. Connect the Program wire (orange wire) to +12Volts DC.
2. Push any button on the remote for 1 second and then release.
3. Disconnect Program wire (orange wire) from +12Volts DC.
4. Remote is now programmed.
Up to 8 remotes can be programmed to any receiver
To clear ALL matched remotes from receiver connect Program wire (orange wire) to
+12Volts DC and firmly press “SELECT” and “FUNCTION+” buttons
simultaneously for 15 seconds.
Battery Installation
1. Use 2 x 3 volt CR2032 coin cell batteries
2. Open the back panel by removing all 8 screws
3. Remove 2 old batteries and replace with fresh battery, be sure to note correct polarity
4. Replace back panel
Program Wire
Antenna Wire
1/8
th
(3.5mm) Jack
RECEIVER MODULE